Connecting Rod Drawing
Connecting Rod drawing
Hello and welcome to our site. We hope this connecting rod drawing information will interest you. Check out the connecting rod drawing auctions listed below from Ebay which we recommend as the best source for products and competitive pricing.
 |
No items matching your keywords were found.
Connecting Rod Assembly in solid edge v19 Part 1
i was drawing the piston connecting rod manually but i could not draw the curved part. can u help me?
u may see the piston connecting rod on following address http://tpub.com/engine3/en3_files/image102.jpg i was unable to draw the connecting rod's curved part as i do not know it center.
If you are drafting by hand or by program, you will need to know the radius of the curve. I assume you already know that but do not know the center point.
For drafting by hand:
Merely, make a light line offset from each of the straight lines by the radius known. From the intersection point, you find the center of the curvature. You can then make the curvature from the intersection of the circle made from the center point with the straight lines.
By Program:
If you are using a program to draft, such as AutoCAD or Microstation, it is much easier. There are buttons you can use to quickly draft the curve. (In AutoCAD, I know its just the fillet button.)
Dodge neon 2.0 DOHC Turbo help?
i have a garrett T3 turbo and intercooler, but my question is about the oil lines where do i route them from? i know the return line goes to the OIl pan but where exactly do i draw the feed line from? the only thing i can come up with without tearing everything down yet is get an adapter where the Oil filter is. im kinda lost with that one all other mods will be done
JE turbo Pistons .020 over bore
Eagle H Beam Connecting Rods
Balanceing of the crankshaft
Indy intake Manifold
2.5" intercooler tubeing
Walboro High Flow Fuel Pump
MPx Billet Aluminum Throttle Body 60mm
Accel fuel injectors.. 24lbs/hr
Moroso Aluminum Racing Oil Pan
and more. . .
is there anyothe suggestions with the Oil feed line ordeal im having? or what else i can do to this engine???
There should be an oil galley plug ob the back of the motor similar to the one the oil sending unit goes into . That should give youplenty of pressure and volume .